Check the trailer’s reflective markings after bodywork

A door, corner post or liftgate repair can leave a gap in the trailer’s nighttime outline. Check the upper corners, lower rear and guard as separate parts of the job.

A fleet technician checks red-and-white reflective tape along a trailer sill near its rear corner.
Industry sponsor Pro FleetSync - TMS Keep drivers, dispatch, safety, and maintenance working from one operating view. Explore Pro FleetSync

A replacement swing door can close cleanly and still leave one upper corner of a dry van without its white reflective markings. A liftgate can create a different problem by hiding tape that is still attached behind it. Both are easy to miss if the final walk-around follows only the metalwork on the invoice. After work on a trailer’s rear, stand behind the finished unit in its road configuration and check what a following driver can see.

The federal in-service rule, 49 CFR 393.11(b), applies to trailers made on or after December 1, 1993, that are at least 80 inches wide and rated at more than 10,000 pounds GVWR. It excepts pole trailers and trailers designed exclusively for living or office use. Covered units use qualifying retroreflective sheeting, conspicuity reflex reflectors, or a combination. This resource focuses on tape-equipped dry vans with rear impact guards, a common configuration across U.S. fleets.

Federal Motor Vehicle Safety Standard No. 108 gives the rear of that trailer three distinct elements. Start high and look for a white horizontal and vertical strip at each upper corner. Then look for the alternating red-and-white band marking the width of the trailer body near the lower rear. Finally, look for the separate red-and-white band across the horizontal member of the rear impact guard. Make those three lines on the work order distinct enough that the person checking them can say exactly which one is missing, damaged or hidden.

A Wabash filing in NHTSA recall 22V758 illustrates what can happen when the hardware changes. On the affected vans, the installed liftgates hid the factory tape at rear deck height. The remedy called for tape in a specified location on the rear-facing surface of the liftgate ramps. In a separate filing, recall 26V323, Wabash reported that a customer citation led it to examine photos showing missing tape across the rear deck. Both filings concern specific vehicles. For other equipment, ask the trailer or equipment manufacturer which layout applies to the finished configuration.

Translate that into a repair handoff. Before disassembly, photograph the whole rear and any side area the job will touch, then identify those locations on the work order. Use the photos to see what changed and confirm the intended pattern against the applicable standard and manufacturer information. If a corner post or side panel was replaced, check the nearby side markings too. The standard allows gaps in the side pattern with coverage and spacing conditions, so a gap needs to be understood in the context of the whole side.

At closeout, look for paint overspray, loose edges and equipment that blocks the view with the doors shut and the liftgate stowed. When replacing sheeting, verify the appropriate DOT-C2, DOT-C3 or DOT-C4 certification marking and the material and placement specified for that location. The standard also addresses spacing from required lamps. A photo from directly behind the finished trailer is a useful shop record, paired with a close-up of the repaired area. If the returned trailer has a blank corner or a hidden band, send the specific location back to the repair lead so it can be resolved before release.